Dome Home Automation Motion Detector Z-Wave – Light Sensor – Magnetic Mount , White (DMMS1)
- PERFECT FOR HOME SECURITY SYSTEMS – Z-Wave Plus Certified and compatible with Z-Wave Hubs, to seamlessly integrate with Wink, SmartThings, Home Seer, Nexia, and other hubs
- SENSES MOTION AND AMBIENT LIGHT – Senses current lighting conditions and helps create smart lighting scenes that optimize your personal safety and home security
- 110-DEGREE MOTION DETECTION FOR ALARM – Detects movement with extra-wide 110-degree coverage and responds by sending an alert to your smart home alarm system
- BATTERY-POWERED TO INSTALL ALMOST ANYWHERE – Magnetic mount and battery operation (3-year battery life) for flexible installation in nearly any area of your home
- ADJUSTABLE SENSITIVITY – Don’t send your neighbors into a panic every time Rover and Spot enter a room
Dome Z-Wave Motion Detector Dome now officially Works with Wink! Your home security system just got bumped up a notch. If anyone is moving along where they shouldn’t be, you’ll know about it. Lights will go on and sirens will blare–should you choose, or maybe just a notification to your smartphone will be enough, but you get the picture. With the Dome Home Automation Motion Detector you can program your Z-Wave hub to light the way when you enter a room, automatically turn on only the lights
List Price: $ 44.99
Price: $ 44.97
Finally… This motion detector actually works well …,
My go control motion detector is the opposite. It doesn’t read but made once every 10 minutes. It makes it worthless for setting up automations.
I plan on ordering more once my budget allows
Was this review helpful to you?
|not bad if you are into dimples,
As far as the internals are concern, Dome and Zooz sensors are the same, including firmware and more importantly, bugs is firmware.
I originally purchased Zooz and the seller, after two rounds of replacements, sent me the Dome sensor. However, the latter has the same problem as the Zooz sensors. At the end of no-motion timeout period, the device sends No-Motion message (as expected) but then, it immediately follows with Motion-Detected message, and the whole sequence repeats several times. I tried the sensors with Smartthings v2 and Homeseer; and clearly, the issue is not controller-related.
I called Dome. After a couple of days, their tech support emailed me and originally, it looked like they were interested in resolving the issue. However, after a few email exchanges, Dome apparently moved to more important things.
Was this review helpful to you?
|Best of the Z-Wave motion detectors I’ve used so far,
Was this review helpful to you?
|